CHARACTERISTICS

EN: Worm geared motors plus final planetary reduction stage. DC motors from 37 to 150 W with permanent magnets. Centre distance 26 mm.

USA: Worm geared motors plus final planetary reduction stage. DC motors from 1/20 to 1/5 HP with permanent magnets. Centre distance 1.02 in.

MP MOTOR:

Continuous current with permanent magnets, totally enclosed with external ventilation. Winding Class F. Power 12 or 24 Vdc. Absorbed power 60 W. Protection IP 65 in compliance with IEC/EN 60529 standards.

MP3N-MP4N MOTOR:

Continuous current with permanent magnets, totally enclosed without external ventilation. Insulation Class F. Power 12 or 24 Vdc. Absorbed power 230 W. Protection IP65 in compliance with IEC/EN 60529 standards.

GEAR UNIT:

with worm screw with die-cast aluminium gearcase in the first gear stage and planetary steel gearcase in the second stage . 26 mm centre distance. CARO bronze crown with a hardness of 120÷160 HB. The worm is made of tempered steel, with ground thread. Seal rings in special high-temperature rubber. Lubrication with special long-lasting oil. There are 9 available gear ratios, from 37.5 to 400.

Version B3 (B3/S left – B3/D right) – B5 (B5/S left – B5/D right).

N.B:

To choose the right gear motor, please refer to the relevant charts for duty and maximum shaft load coefficients.

These gear motors need to be run in. Therefore, for approximately the first 30 operating hours the torque will be lower than what indicated in the data.

Download:

Brake